Includes all hardware needed (screws) to install a license plate on the front of your vehicle. ![]() #Honda fit front license plate installation install# Some of the hardware will not come in Honda packaging. Once you have it centered, take your pen and mark inside the mounting holes on the bracket. This will either be two hole or four depending on the bracket you have purchased. Once this is done, put your bracket aside, and using a level make sure the guide holes marked are level. If you are just mounting the plate directly to the front end of the vehicle, follow the same procedure but with the hole on the license instead. Once you are feeling good about your measurements, take your 1/8 inch drill bit and drill holes into the guide holes you marked in step 3. When drilling, keep the drill at a 90 degree angle and keep the holes shallow. ![]() ![]() Now that the hard part is over, take your bracket and line it up with the hole you have just made. ![]() Next, take your screwdriver and twist the screws in, in a clockwise direction. #Honda fit front license plate installation install#.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |